Controller IC Chip - MOSFET EN25QH64-104HIP EN25QH64 chip for laptop - Integrated Laptop Chip (Code 1-CHIP0388)

Controller IC Chip - MOSFET EN25QH64-104HIP EN25QH64 chip for laptop- Integrated portable calculator chip(SKU.1-CHIP0388)

The EN25QH64 is a 64 Megabit (8,192 K-byte) Serial Flash memory, with enhanced write protection mechanisms. The EN25QH64 supports the standard Serial Peripheral Interface (SPI), and a high performance Dual/Quad output as well as Dual/Quad I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI), DQ1(DO), DQ2(WP#) and DQ3(HOLD#). SPI clock frequencies of up to 80MHz are supported allowing equivalent clock rates of 160MHz (80MHz x 2) for Dual Output when using the Dual Output Fast Read instructions, and SPI clock frequencies of up to 80MHz are supported allowing equivalent clock rates of 320MHz (80MHz x 4) for Quad Output when using the Quad Output Fast Read instructions. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. The EN25QH64 is designed to allow either single Sector/Block at a time or full chip erase operation. The EN25QH64 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector or block

Single power supply operation - Full voltage range: 2.7-3.6 volt • Serial Interface Architecture - SPI Compatible: Mode 0 and Mode 3 • 64 M-bit Serial Flash - 64 M-bit/8,192 K-byte/32,768 pages - 256 bytes per programmable page • Standard, Dual or Quad SPI - Standard SPI: CLK, CS#, DI, DO, WP#, HOLD# - Dual SPI: CLK, CS#, DQ0, DQ1, WP#, HOLD# - Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3• High performance - 104MHz clock rate for Standard SPI - 80MHz clock rate for two data bits - 80MHz clock rate for four data bits • Low power consumption - 12 mA typical active current - 1 mA typical power down current • Uniform Sector Architecture: - 2048 sectors of 4-Kbyte - 128 blocks of 64-Kbyte - Any sector or block can be erased individually • Software and Hardware Write Protection: - Write Protect all or portion of memory via software - Enable/Disable protection with WP# pin • High performance program/erase speed - Page program time: 1.3ms typical - Sector erase time: 60ms typical - Block erase time 300ms typical - Chip erase time: 30 seconds typical • Lockable 512 byte OTP security sector• Support Serial Flash Discoverable Parameters (SFDP) signature• Read Unique ID Number• Minimum 100K endurance cycle• Package Options - 8 pins SOP 200mil body width - 8 contact VDFN (5x6mm) - 8 contact VDFN (6x8mm) - 8 pins PDIP - 16 pins SOP 300mil body width - 24 balls TFBGA (6x8mm)- All Pb-free packages are compliant RoHS, Halogen-Free and REACH. • Industrial temperature Range

Please check the IC Number and match with your existing Product.

When you receive before using it.

Please confirm the chip you received is brand new as described,if you suspect the chip is not new or not as described. Please don't use it and contact us immediately.

Please make sure you have advanced soldering skill to solder the chips that you will order.

Once it has been used, no return will be accepted.